302 - EC

EC 1017

EL.30.01017

Application
The coordinated standard ballbearing table is designed to allow 2 crossed movements at 90°. It is based on the same principle as the ES-1; the ballbearing support has two times 2 borings for the ball bearings.
Design
The ball-bearing support and the 4 shaft supports are made of grey cast iron, ground on all sides.
Precision
The distance between the shafts is constant within 5 µm. The parallelism between the fixing bases and the shafts is within 10 µm, depending on the quality of the chosen shafts and ball bearings. Perpendicularity is 10 µm per 100 mm.

Product Number EL.30.01017
Product Designation EC 1017
Outer diameter D 0
Inner diameter d 0
Dynamic factor Y 0.000000
Diameter pins PB G 5
Diameter Counterbore W 10
Diameter screw slot V 5.5
Diameter frontal hole PB t 5
Diameter frontal hole PR T 8
Diameter shaft hole d 10
Diameter bearing holes D 17
Difference height PB-PR Y 2
Center distance pin PB A 68
Center distance shaft holes C 50
Center distance bearing holes in height X 19
Center distance screw PB B 30
Height F 30
Height PRC HC 47
Total height unit H 51
Height shaft holes K 16
Width L 80
Length bar holder PB 14
Material GG
Depth Counterbore U 5.5

302 - EC

Download

EC 1017

EL.30.01017

302 - EC

Application
The coordinated standard ballbearing table is designed to allow 2 crossed movements at 90°. It is based on the same principle as the ES-1; the ballbearing support has two times 2 borings for the ball bearings.
Design
The ball-bearing support and the 4 shaft supports are made of grey cast iron, ground on all sides.
Precision
The distance between the shafts is constant within 5 µm. The parallelism between the fixing bases and the shafts is within 10 µm, depending on the quality of the chosen shafts and ball bearings. Perpendicularity is 10 µm per 100 mm.

Inner diameter d

0 mm

Outer diameter D

0 mm

302 - EC