302 - EC

EC 2540

EL.30.02540

Application
The coordinated standard ballbearing table is designed to allow 2 crossed movements at 90°. It is based on the same principle as the ES-1; the ballbearing support has two times 2 borings for the ball bearings.
Design
The ball-bearing support and the 4 shaft supports are made of grey cast iron, ground on all sides.
Precision
The distance between the shafts is constant within 5 m. The parallelism between the fixing bases and the shafts is within 10 m, depending on the quality of the chosen shafts and ball bearings. Perpendicularity is 10 m per 100 mm.

Product Number EL.30.02540
Product Designation EC 2540
Outer diameter D 0
Inner diameter d 0
Dynamic factor Y 0.000000
Diameter pins PB G 6
Diameter Counterbore W 11
Diameter screw slot V 6.5
Diameter frontal hole PB t 5
Diameter frontal hole PR T 10
Diameter shaft hole d 25
Diameter bearing holes D 40
Difference height PB-PR Y 2
Center distance pin PB A 114
Center distance shaft holes C 80
Center distance bearing holes in height X 42
Center distance screw PB B 42
Height F 54
Height PRC HC 94
Total height unit H 98
Height shaft holes K 28
Width L 132
Length bar holder PB 22
Material GG
Depth Counterbore U 6.5

302 - EC

Download

EC 2540

EL.30.02540

302 - EC

Application
The coordinated standard ballbearing table is designed to allow 2 crossed movements at 90°. It is based on the same principle as the ES-1; the ballbearing support has two times 2 borings for the ball bearings.
Design
The ball-bearing support and the 4 shaft supports are made of grey cast iron, ground on all sides.
Precision
The distance between the shafts is constant within 5 m. The parallelism between the fixing bases and the shafts is within 10 m, depending on the quality of the chosen shafts and ball bearings. Perpendicularity is 10 m per 100 mm.

Internal diameter

0 mm

Outside diameter

0 mm

302 - EC