302 - EC

EC 5075

EL.30.05075

Application
The coordinated standard ballbearing table is designed to allow 2 crossed movements at 90°. It is based on the same principle as the ES-1; the ballbearing support has two times 2 borings for the ball bearings.
Design
The ball-bearing support and the 4 shaft supports are made of grey cast iron, ground on all sides.
Precision
The distance between the shafts is constant within 5 m. The parallelism between the fixing bases and the shafts is within 10 m, depending on the quality of the chosen shafts and ball bearings. Perpendicularity is 10 m per 100 mm.

Product Number EL.30.05075
Product Designation EC 5075
Outer diameter D 0
Inner diameter d 0
Dynamic factor Y 0.000000
Diameter pins PB G 8
Diameter Counterbore W 18
Diameter screw slot V 10.5
Diameter frontal hole PB t 6
Diameter frontal hole PR T 12
Diameter shaft hole d 50
Diameter bearing holes D 75
Difference height PB-PR Y 3
Center distance pin PB A 210
Center distance shaft holes C 145
Center distance bearing holes in height X 77
Center distance screw PB B 70
Height F 97
Height PRC HC 171
Total height unit H 177
Height shaft holes K 50
Width L 240
Length bar holder PB 40
Material GG
Depth Counterbore U 12

302 - EC

Download

EC 5075

EL.30.05075

302 - EC

Application
The coordinated standard ballbearing table is designed to allow 2 crossed movements at 90°. It is based on the same principle as the ES-1; the ballbearing support has two times 2 borings for the ball bearings.
Design
The ball-bearing support and the 4 shaft supports are made of grey cast iron, ground on all sides.
Precision
The distance between the shafts is constant within 5 m. The parallelism between the fixing bases and the shafts is within 10 m, depending on the quality of the chosen shafts and ball bearings. Perpendicularity is 10 m per 100 mm.

Inner diameter d

0 mm

Outer diameter D

0 mm

302 - EC